Description: Automatic Transfer Switch (ATS)

• Control device: Built-in controller

  
  

• Product structure: No power off, guide rail type, high current, small volume, two-stage type simple structure, ATS integration.

  
  

• Features: Fast switching speed, low failure rate, convenient maintenance, and reliable performance.

  
  

• Wiring mode: Front plate wiring

  
  

• Conversion mode: Power grid to power grid, power grid to generator, photovoltaic to urban power, automatic switching and self-recovery.

  
  

• Product frame: 100

  
  

• Product current: 10, 16, 20, 25, 32, 40, 50, 63, 80, 100A

  
  

• Product classification: Direct load type

  
  

• Pole No.: 2, 3, 4

  
  

• Standard: GB/T14048.11

  
  

• A T S E: PC class

  
  

• Switching time: 0.008s / 8ms
  

Core Application

• Primary Function: Used to monitor whether the main power supply or standby power supply is normal.

• Emergency Operation: When the normal power supply fails, the standby power starts immediately to ensure the continuity, reliability, and safety of the power supply.

• Installation: Specifically designed for household rail installation and optimized for use in PZ30 distribution boxes.

Technical Characteristics

• Electrical Compatibility: Suitable for emergency power systems with 50Hz or 60Hz and a rated voltage of 400V AC.

• Design: Features a solid structure with reliable conversion and is designed for a long service life.

• Operation: Can be operated both electrically and manually.

• Components: Composed of TSE (Transfer Switching Equipment) and a controller.

Standards and Compliance

• Certification: Formulated according to GB/T14048.11, Part 6-1: Multifunctional equipment and switchgear.

• Classification: Recognized as a qualified low-voltage switchgear and control device.
  

Automatic Transfer Switch (ATS) Operation and Installation

Normal Operation Time and Installation Conditions

• Ambient air temperature:

  • The maximum temperature shall not exceed 40°C.

  • The minimum temperature shall not be lower than -5°C.

  • The average temperature within 24 hours shall not be higher than 35°C.

• Altitude: The altitude of the installation site should not be higher than 2000m.

• Atmospheric conditions:

  • When the maximum temperature reaches 40°C, the relative humidity of the installation site should not exceed 50%.

  • When the temperature is at the minimum (-5°C), higher relative humidity is allowed (e.g., 90% at 25°C).

  • Special measures should be taken to deal with occasional condensation on the surface of the product due to temperature changes.

• Pollution grade: The pollution grade of ATS conforms to grade 3 specified in GB/T14048.11.

• Installation category: The installation type of ATS conforms to the category specified in GB/T14048.11.

• Installation conditions: ATS can be installed vertically in a control cabinet or distribution cabinet. Ensure the installation distance meets the requirements in Figure 1.

Technical Summary of the ATS

• Control device: Built-in controller

• Product structure: No power off, guide rail type, high current, small volume, two-stage simple structure, ATS integration.

• Features: Fast switching speed, low failure rate, convenient maintenance, and reliable performance.

  
  

• Wiring mode: Front plate wiring.

  
  

• Conversion mode: Power grid to power grid, power grid to generator, photovoltaic to urban power, automatic switching and self-recovery.

  
  

• Product frame: 100

  
  

• Product current: 10, 16, 20, 25, 32, 40, 50, 63, 80, 100A.

  
  

• Pole No.: 2, 3, 4

  
  

• Standard: GB/T14048.11

  
  

• ATSE: PC class

• Switching time: 0.008s / 8ms